v1.2 CANBusShield

• Replacing the CAN Bus driver
• Adding a pull-down resistor to the CS pin
• Adding a 1nF capacitor to the 120 ohm terminating resistor
  -Adding 2EDN7534F (54 Gate driver) channels to handle high current outputs; in addition adding a diode to power them if the board is only powered through USB
• Adding TL4050A50IDBZT (Precision micropower shunt voltage) to generate a precise 5V reference
• Adding protection diodes for A0 and A1 analog inputs

Thanks lmre

v1.1_CANBusShield

CANBUS Shield v1.1 for Arduino UNO. To fix CanTX and CanRX wires.

v1.0_CANBusShield

CANBUS Shield v1.0 for Arduino Mega and Arduino UNO